Q1:
AS & A Level Physics - 9702 Paper 2 2010 Summer Zone 3
Share
Previous
Questions:
1/7
Topic: CH2 - MEASUREMENT TECHNIQUES
Solution
PRACTISE
Similar Questions
LEARN
Concepts with Sparky
More Questions from this Topic
Theory
CH2 - MEASUREMENT TECHNIQUES
(a) The list below shows some SI quantities.
Underline the quantity that is not an SI base quantity.
charge current length time [1]
(b) A square so...
Summer
6
Theory
CH2 - MEASUREMENT TECHNIQUES
The drag force $F_D$ acting on an object falling through air is given by
$F_D = \frac{1}{2}C \rho A v^2$
where $A$ is the cross-sectional area of th...
Summer
5
Theory
CH2 - MEASUREMENT TECHNIQUES
The drag force $F_D$ acting on a sphere falling through a liquid is given by
$$F_D = 6 \pi \eta r v$$
where $r$ is the radius of the sphere,
$v$ is...
Summer
6
Theory
CH2 - MEASUREMENT TECHNIQUES
(a) Define density. [1]
(b) Figure 1 shows a cuboidal glass block.
A student measures the mass $m$ of the block and the side lengths $...
Winter
5
MCQ
CH2 - MEASUREMENT TECHNIQUES
The value of quantity $X$ has a percentage uncertainty of 2%.The value of quantity $Y$ has a percentage uncertainty of 4%.The value of a quantity $W$ ...
Summer
6
MCQ
CH2 - MEASUREMENT TECHNIQUES
What is a reasonable estimate of the mass of a solid sphere of copper that has a diameter of 60 cm?
Winter
5
MCQ
CH2 - MEASUREMENT TECHNIQUES
A solid bar has a square cross-section. Its length is measured as 50.0 ± 0.2 cm and its width is measured as 2.00 ± 0.01 cm.These values are used to...
Winter
4
MCQ
CH2 - MEASUREMENT TECHNIQUES
The density of the material of a rectangular block is determined by measuring the mass and linear dimensions of the block. The list shows the results ...
Winter
3
MCQ
CH2 - MEASUREMENT TECHNIQUES
What is a reasonable estimate of the volume of one page from this examination paper?
Winter
4
MCQ
CH2 - MEASUREMENT TECHNIQUES
A thermometer can be read to an accuracy of ±0.5°C. This thermometer is used to measure a temperature rise from 40°C to 100°C. What is the percent...
Summer
4
More Questions from year 2010
MCQ
CH1 - PHYSICAL QUANTITIES & UNITS
The SI unit for potential difference (the volt) is given, in base units, by
Summer
1
MCQ
CH1 - PHYSICAL QUANTITIES & UNITS
The product of pressure and volume has the same SI base units as
Summer
3
MCQ
CH1 - PHYSICAL QUANTITIES & UNITS
An ion is accelerated by a series of electrodes in a vacuum. A graph of the power supplied to the ion is plotted against time.What is represented by t...
Summer
1
MCQ
CH1 - PHYSICAL QUANTITIES & UNITS
A vector quantity $V$ is resolved into two perpendicular components $X$ and $Y$. The angle between $V$ and component $X$ is $\theta$. The angle betwee...
Summer
1
MCQ
CH3 - KINEMATICS
The diagram shows a velocity-time graph for a vehicle.
The vehicle, moving at 4.0 ms-1, begins to accelerate at time = 0.
What is the vehicle's ac...
Summer
2
MCQ
CH3 - KINEMATICS
A small steel ball falls freely under gravity after being released from rest.
Which graph best represents the variation of the height $h$ of the ball...
Summer
1
MCQ
CH4 - DYNAMICS
Two equal masses travel towards each other on a frictionless air track at speeds of $60 \text{ cm s}^{-1}$ and $40 \text{ cm s}^{-1}$. They stick toge...
Summer
2
MCQ
CH4 - DYNAMICS
A brick weighing 20 N rests on an inclined plane. The weight of the brick has a component of 10 N parallel with the plane. The brick also experiences ...
Summer
2
MCQ
CH4 - DYNAMICS
The diagram shows two identical spheres X and Y.
Initially, X moves with speed v directly towards Y. Y is stationary. The spheres collide elastical...
Summer
3
MCQ
CH5 - FORCES, DENSITY & PRESSURE
Forces of 3 N, 4 N and 5 N act at one point on an object. The angles at which the forces act can vary.
What is the value of the minimum resultant for...
Summer
3