Q25:
AS & A Level Physics - 9702 Paper 1 2014 Winter Zone 3
Share
Previous
Questions:
25/40
Topic: CH9 - DEFORMATION OF SOLIDS
Solution
Solution is C,C
PRACTISE
Similar Questions
LEARN
Concepts with Sparky
More Questions from this Topic
Theory
CH9 - DEFORMATION OF SOLIDS
(a) State Hooke's law. [1]
(b) The variation of the applied force with the extension for a sample of a material is shown in Fig. 3.1.
...
Summer
10
Theory
CH9 - DEFORMATION OF SOLIDS
(a) Define strain. [1]
(b) A copper wire of length 4.0 m has a uniform cross-sectional area of $4.5 \times 10^{-7} \text{ m}^2$.
A tensi...
Summer
3
Theory
CH9 - DEFORMATION OF SOLIDS
(a) The variation of stress with strain for a metal P is shown in Figure 1.
Point E is the elastic limit of the metal.
(i) Use Figure 1 to determi...
Winter
4
Theory
CH9 - DEFORMATION OF SOLIDS
(a) Define:
(i) stress [1]
(ii) strain [1]
(b) Two wires X and Y, with equal unstretched lengths of 0.84 m, are suspended ...
Winter
8
Theory
CH9 - DEFORMATION OF SOLIDS
(a) Define the Young modulus of a material. [1]
(b) A metal wire P that obeys Hooke’s law is stretched within its limit of proport...
Winter
5
MCQ
CH9 - DEFORMATION OF SOLIDS
A sample of metal is subjected to a force which increases to a maximum value and then decreases back to zero. A force–extension graph for the sa...
Summer
4
MCQ
CH9 - DEFORMATION OF SOLIDS
Two wires, P and Q, made of the same material, are stretched with an increasing force.
A graph is plotted of the variation with force of the extensio...
Summer
5
MCQ
CH9 - DEFORMATION OF SOLIDS
An extension–force graph for a spring is shown.
What is the spring constant of the spring?
Summer
3
MCQ
CH9 - DEFORMATION OF SOLIDS
What is a unit for stress?
Winter
6
MCQ
CH9 - DEFORMATION OF SOLIDS
A wire has original length $L$ and cross-sectional area $A$. A tensile force $F$ is applied to the wire which causes it to have extension $x$. The wir...
Winter
4
More Questions from year 2014
MCQ
CH1 - PHYSICAL QUANTITIES & UNITS
Which quantity can be measured in electronvolts (eV)?
Summer
2
MCQ
CH1 - PHYSICAL QUANTITIES & UNITS
The unit of specific heat capacity is $\text{J kg}^{-1} \text{K}^{-1}$.What is its equivalent in terms of SI base units?
Summer
2
MCQ
CH1 - PHYSICAL QUANTITIES & UNITS
What is the vertical component of this displacement vector?
Summer
2
MCQ
CH2 - MEASUREMENT TECHNIQUES
The resistance of a lamp is calculated from the value of the potential difference (p.d.) across it and the value of the current passing through it.Whi...
Summer
2
MCQ
CH2 - MEASUREMENT TECHNIQUES
The display on a cathode-ray oscilloscope shows the signal produced by an electronic circuit. The time-base is set at 5.0 ns per division and the Y-ga...
Summer
2
MCQ
CH2 - MEASUREMENT TECHNIQUES
A digital caliper is used to measure the 28.50 mm width of a plastic ruler. The digital caliper reads to the nearest 0.01 mm. What is the correct way...
Summer
2
MCQ
CH3 - KINEMATICS
An experiment is performed to measure the acceleration of free fall $g$. A body falls between two fixed points. The four measurements shown below are ...
Summer
2
MCQ
CH3 - KINEMATICS
In a cathode-ray tube, an electron is accelerated uniformly in a straight line from a speed of $4 \times 10^{3} \: \text{ms}^{-1}$ to $2 \times 10^{7}...
Summer
2
MCQ
CH3 - KINEMATICS
The graph shows how the speed $v$ of a sprinter changes with time $t$ during a 100 m race.
What is the best estimate of the maximum acceleration of...
Summer
2
MCQ
CH4 - DYNAMICS
A tennis ball is dropped onto a table and bounces back up. The table exerts a force F on the ball.
Which graph best shows the variation with time t o...
Summer
2