Q3:
AS & A Level Physics - 9702 Paper 1 2023 Summer Zone 1
Share
Previous
Questions:
3/40
Topic: CH2 - MEASUREMENT TECHNIQUES
Solution
Solution is D
PRACTISE
Similar Questions
LEARN
Concepts with Sparky
More Questions from this Topic
Theory
CH2 - MEASUREMENT TECHNIQUES
(a) The list below shows some SI quantities.
Underline the quantity that is not an SI base quantity.
charge current length time [1]
(b) A square so...
Summer
5
Theory
CH2 - MEASUREMENT TECHNIQUES
The drag force $F_D$ acting on an object falling through air is given by
$F_D = \frac{1}{2}C \rho A v^2$
where $A$ is the cross-sectional area of th...
Summer
3
Theory
CH2 - MEASUREMENT TECHNIQUES
The drag force $F_D$ acting on a sphere falling through a liquid is given by
$$F_D = 6 \pi \eta r v$$
where $r$ is the radius of the sphere,
$v$ is...
Summer
5
Theory
CH2 - MEASUREMENT TECHNIQUES
(a) Define density. [1]
(b) Figure 1 shows a cuboidal glass block.
A student measures the mass $m$ of the block and the side lengths $...
Winter
5
MCQ
CH2 - MEASUREMENT TECHNIQUES
The value of quantity $X$ has a percentage uncertainty of 2%.The value of quantity $Y$ has a percentage uncertainty of 4%.The value of a quantity $W$ ...
Summer
3
MCQ
CH2 - MEASUREMENT TECHNIQUES
What is a reasonable estimate of the mass of a solid sphere of copper that has a diameter of 60 cm?
Winter
5
MCQ
CH2 - MEASUREMENT TECHNIQUES
A solid bar has a square cross-section. Its length is measured as 50.0 ± 0.2 cm and its width is measured as 2.00 ± 0.01 cm.These values are used to...
Winter
4
MCQ
CH2 - MEASUREMENT TECHNIQUES
The density of the material of a rectangular block is determined by measuring the mass and linear dimensions of the block. The list shows the results ...
Winter
3
MCQ
CH2 - MEASUREMENT TECHNIQUES
What is a reasonable estimate of the volume of one page from this examination paper?
Winter
4
MCQ
CH2 - MEASUREMENT TECHNIQUES
A thermometer can be read to an accuracy of ±0.5°C. This thermometer is used to measure a temperature rise from 40°C to 100°C. What is the percent...
Summer
4
More Questions from year 2023
MCQ
CH1 - PHYSICAL QUANTITIES & UNITS
Which unit is not an SI base unit?
Summer
3
MCQ
CH2 - MEASUREMENT TECHNIQUES
What is the best estimate of the number of atoms in a piece of metal of volume 50 cm$^3$?
Summer
3
MCQ
CH2 - MEASUREMENT TECHNIQUES
A copper pipe has a true diameter of 42.03 mm.A builder measures the diameter of the pipe five times using digital calipers. The measurements are show...
Summer
3
MCQ
CH3 - KINEMATICS
Two forces, each of 10 N, act at a point P, as shown. The angle between the directions of the forces is 120°. What is the magnitude of the result...
Summer
2
MCQ
CH3 - KINEMATICS
One object moves directly from P to R.
In a shorter time, a second object moves from P to Q to R.
Which statement about the two objects is correct...
Summer
3
MCQ
CH3 - KINEMATICS
A ball is kicked so that it has an initial velocity of 12 m s⁻¹ at an angle of 50° to horizontal ground.
Assume that air resistance is neg...
Summer
2
MCQ
CH4 - DYNAMICS
A camera drone of mass 1.20 kg hovers at a fixed point above the ground. The drone has four propellers.
In a time of 1.00 s, each propeller pushes ...
Summer
2
MCQ
CH4 - DYNAMICS
A box rests on the Earth, as shown.
Newton’s third law describes how forces of the same type act in pairs. One of the forces of a pair is the w...
Summer
3
MCQ
CH5 - FORCES, DENSITY & PRESSURE
A small ball is held at the surface of liquid oil in a container. The ball is released from rest and falls through the oil. The ball has velocity $v$....
Summer
3
MCQ
CH4 - DYNAMICS
An object of mass $m$, moving at speed $u$ along a frictionless horizontal surface, collides head-on with a stationary object of mass $4m$.
After t...
Summer
2