Q4:
AS & A Level Physics - 9702 Paper 2 2011 Winter Zone 1
Share
Previous
Questions:
4/7
Topic: Power
Solution
PRACTISE
Similar Questions
LEARN
Concepts with Sparky
More Questions from this Topic
MCQ
Power
A force of 1000 N is needed to lift the hook of a crane at a steady velocity. The crane is then used to lift a load of mass 1000 kg at a velocity of 0...
Summer
3
MCQ
Power
What are units of work, energy and power?
Winter
3
MCQ
Power
A force of 1000 N is needed to lift the hook of a crane at a steady velocity. The crane is then used to lift a load of mass 1000 kg at a velocity of 0...
Summer
2
MCQ
Power
A steam turbine is used to drive a generator. The input power to the turbine is $P_I$ and the output power $P_O$. The power loss in the turbine is $P_...
Winter
2
MCQ
Power
The diagram shows a lift system in which the elevator (mass $m_1$) is partly counterbalanced by a heavy weight (mass $m_2$).
At what rate does the mo...
Winter
3
Theory
Power
(a) Distinguish between gravitational potential energy and electric potential energy. [2]
(b) A body of mass $m$ moves vertically through a dist...
Winter
3
MCQ
Power
The force resisting the motion of a car is taken as being proportional to the square of the car’s speed. The magnitude of the force at a speed o...
Summer
3
MCQ
Power
A car engine exerts an average force of 500 N in moving the car 1.0 km in 200 s.
What is the average power developed by the engine?
Summer
2
MCQ
Power
An electrical generator is started at time zero. The total electrical energy generated during the first 5 seconds is shown in the graph.
What is th...
Winter
3
MCQ
Power
A turbine at a hydroelectric power station is situated 30 m below the level of the surface of a large lake. The water passes through the turbine at a ...
Winter
3
More Questions from year 2011
Theory
CH2 - MEASUREMENT TECHNIQUES
Measurements made for a sample of metal wire are shown in Fig. 1.1.
Fig. 1.1
(a) State the appropriate instruments used to make each of these meas...
Summer
2
Theory
Kinetic Energy
(a) Explain what is meant by work done. [1]
(b) A car is travelling along a road that has a uniform downhill gradient, as shown in Fig. 2.1.
...
Summer
3
Theory
CH5 - FORCES, DENSITY & PRESSURE
(a) Explain what is meant by centre of gravity.
(b) Define moment of a force.
(c) A student is being weighed. The student, of weight $W$, stands 0.3...
Summer
3
Theory
CH9 - DEFORMATION OF SOLIDS
(a) Define, for a wire,
(i) stress, [1]
(ii) strain. [1]
(b) A wire of length 1.70 m hangs vertically from a fixed point,...
Summer
3
Theory
CH20 - D.C. CIRCUITS
(a) A variable resistor is used to control the current in a circuit, as shown in Fig. 5.1. The variable resistor is connected in series with a 12V po...
Summer
1
Theory
CH5 - FORCES, DENSITY & PRESSURE
(a) State two assumptions of the simple kinetic model of a gas. [2]
(b) Use the kinetic model of gases and Newton's laws of motion to exp...
Summer
3
Theory
CH15 - SUPERPOSITION
(a) Explain the term interference. [1]
(b) A ripple tank is used to demonstrate interference between water waves.
Describe
(i) the appa...
Summer
2
Theory
CH1 - PHYSICAL QUANTITIES & UNITS
(a) Distinguish between scalar quantities and vector quantities. [2]
(b) In the following list, underline all the scalar quantities.
accelerati...
Summer
4
Theory
CH1 - PHYSICAL QUANTITIES & UNITS
(a) A sphere of radius $R$ is moving through a fluid with constant speed $v$. There is a frictional force $F$ acting on the sphere, which is given by ...
Summer
2
Theory
Potential Energy
(a) (i) Explain what is meant by work done. [1]
(ii) Define power. [1]
(b) Fig. 3.1 shows part of a fairground ride with a carriage on rai...
Summer
2