Theory

CH5 - FORCES, DENSITY & PRESSURE

(a) Define the $\emph{torque}$ of a couple.   [2] (b) A torque wrench is a type of spanner for tightening a nut and bolt to a particular to...

2009 Summer

MCQ

CH5 - FORCES, DENSITY & PRESSURE

What is the centre of gravity of an object?

2009 Winter

MCQ

CH5 - FORCES, DENSITY & PRESSURE

The diagrams show two ways of hanging the same picture. In both cases, a string is attached to the same points on the picture and looped symmetrica...

2009 Winter

MCQ

CH5 - FORCES, DENSITY & PRESSURE

The diagram shows two pulley wheels connected by a belt. Wheel Q is driven by a motor and rotates clockwise at a constant rate. Wheel Q puts tensio...

2009 Winter

MCQ

CH5 - FORCES, DENSITY & PRESSURE

The diagram shows an ice cube floating in water. Both the ice cube and the water are at 0°C. Which statement correctly compares the molecular ...

2009 Winter

MCQ

CH5 - FORCES, DENSITY & PRESSURE

In the kinetic model of gases, what is pressure equal to?

2009 Winter

MCQ

CH5 - FORCES, DENSITY & PRESSURE

A rectangular metal bar exerts a pressure of 15 200 Pa on the horizontal surface on which it rests. If the height of the metal bar is 80 cm, what is ...

2009 Winter

Theory

CH5 - FORCES, DENSITY & PRESSURE

(a) (i) State one similarity between the processes of evaporation and boiling.   [1] (ii) State two differences between the processes of ev...

2009 Winter

MCQ

CH5 - FORCES, DENSITY & PRESSURE

Forces of 3 N, 4 N and 5 N act at one point on an object. The angles at which the forces act can vary. What is the value of the minimum resultant for...

2010 Summer

MCQ

CH5 - FORCES, DENSITY & PRESSURE

An object, immersed in a liquid in a tank, experiences an upthrust. What is the physical reason for this upthrust?

2010 Summer

MCQ

CH1 - PHYSICAL QUANTITIES & UNITS

Which unit is not an SI base unit?

2023 Summer

MCQ

CH2 - MEASUREMENT TECHNIQUES

What is the best estimate of the number of atoms in a piece of metal of volume 50 cm$^3$?

2023 Summer

MCQ

CH2 - MEASUREMENT TECHNIQUES

A copper pipe has a true diameter of 42.03 mm.A builder measures the diameter of the pipe five times using digital calipers. The measurements are show...

2023 Summer

MCQ

CH3 - KINEMATICS

Two forces, each of 10 N, act at a point P, as shown. The angle between the directions of the forces is 120°. What is the magnitude of the result...

2023 Summer

MCQ

CH3 - KINEMATICS

One object moves directly from P to R. In a shorter time, a second object moves from P to Q to R. Which statement about the two objects is correct...

2023 Summer

MCQ

CH3 - KINEMATICS

A ball is kicked so that it has an initial velocity of 12 m s⁻¹ at an angle of 50° to horizontal ground. Assume that air resistance is neg...

2023 Summer

MCQ

CH4 - DYNAMICS

A camera drone of mass 1.20 kg hovers at a fixed point above the ground. The drone has four propellers. In a time of 1.00 s, each propeller pushes ...

2023 Summer

MCQ

CH4 - DYNAMICS

A box rests on the Earth, as shown. Newton’s third law describes how forces of the same type act in pairs. One of the forces of a pair is the w...

2023 Summer

MCQ

CH5 - FORCES, DENSITY & PRESSURE

A small ball is held at the surface of liquid oil in a container. The ball is released from rest and falls through the oil. The ball has velocity $v$....

2023 Summer

MCQ

CH4 - DYNAMICS

An object of mass $m$, moving at speed $u$ along a frictionless horizontal surface, collides head-on with a stationary object of mass $4m$. After t...

2023 Summer