Theory

CH9 - DEFORMATION OF SOLIDS

A spring having spring constant $k$ hangs vertically from a fixed point. A load of weight $L$, when hung from the spring, causes an extension $e$. The...

2009 Summer

MCQ

CH9 - DEFORMATION OF SOLIDS

Which is the  best defines elastic and plastic behaviour of a material?

2009 Winter

MCQ

CH9 - DEFORMATION OF SOLIDS

The graph shows the non-linear force-extension curve for a wire made from a new composite material. What could be the value of the strain energy st...

2009 Winter

MCQ

CH9 - DEFORMATION OF SOLIDS

A steel string on an electric guitar has the following properties: diameter = $5.0 \times 10^{-4}\, \text{m}$ Young modulus = $2.0 \times 10^{11}\, ...

2009 Winter

Theory

CH9 - DEFORMATION OF SOLIDS

A uniform wire has length $L$ and area of cross-section $A$. The wire is fixed at one end so that it hangs vertically with a load attached to its free...

2009 Winter

Theory

CH9 - DEFORMATION OF SOLIDS

(a) Explain what is meant by strain energy (elastic potential energy).   [2] (b) A spring that obeys Hooke's law has a spring constant $k$....

2009 Winter

MCQ

CH9 - DEFORMATION OF SOLIDS

In stress-strain experiments on metal wires, the stress axis is often marked in units of $10^8$ Pa and the strain axis is marked as a percentage. This...

2010 Summer

MCQ

CH9 - DEFORMATION OF SOLIDS

A spring is compressed by a force. The graph shows the compressing force $F$ plotted against the length $L$ of the spring. What is the spring const...

2010 Summer

MCQ

CH9 - DEFORMATION OF SOLIDS

Which graph represents the force-extension relationship of a rubber band that is stretched almost to its breaking point?

2010 Summer

MCQ

CH9 - DEFORMATION OF SOLIDS

A spring is compressed by a force. The graph shows the compressing force $F$ plotted against the length $L$ of the spring What is the spring consta...

2010 Summer

Theory

CH2 - MEASUREMENT TECHNIQUES

Measurements made for a sample of metal wire are shown in Fig. 1.1. Fig. 1.1 (a) State the appropriate instruments used to make each of these meas...

2011 Summer

Theory

Kinetic Energy

(a) Explain what is meant by work done. [1] (b) A car is travelling along a road that has a uniform downhill gradient, as shown in Fig. 2.1. ...

2011 Summer

Theory

CH5 - FORCES, DENSITY & PRESSURE

(a) Explain what is meant by centre of gravity. (b) Define moment of a force. (c) A student is being weighed. The student, of weight $W$, stands 0.3...

2011 Summer

Theory

CH9 - DEFORMATION OF SOLIDS

(a) Define, for a wire, (i) stress,    [1] (ii) strain.    [1] (b) A wire of length 1.70 m hangs vertically from a fixed point,...

2011 Summer

Theory

CH20 - D.C. CIRCUITS

(a) A variable resistor is used to control the current in a circuit, as shown in Fig. 5.1. The variable resistor is connected in series with a 12V po...

2011 Summer

Theory

CH5 - FORCES, DENSITY & PRESSURE

(a) State two assumptions of the simple kinetic model of a gas.   [2] (b) Use the kinetic model of gases and Newton's laws of motion to exp...

2011 Summer

Theory

CH15 - SUPERPOSITION

(a) Explain the term interference.   [1] (b) A ripple tank is used to demonstrate interference between water waves. Describe (i) the appa...

2011 Summer

Theory

CH1 - PHYSICAL QUANTITIES & UNITS

(a) Distinguish between scalar quantities and vector quantities. [2] (b) In the following list, underline all the scalar quantities. accelerati...

2011 Summer

Theory

CH1 - PHYSICAL QUANTITIES & UNITS

(a) A sphere of radius $R$ is moving through a fluid with constant speed $v$. There is a frictional force $F$ acting on the sphere, which is given by ...

2011 Summer

Theory

Potential Energy

(a) (i) Explain what is meant by work done. [1] (ii) Define power. [1] (b) Fig. 3.1 shows part of a fairground ride with a carriage on rai...

2011 Summer